Page007

Back End Plate / Lead Exit Inserts

	This view shows the inside face of the Back End Plate. The 2 Lead Exit Inserts (modified #8-32 Nylon Screws) are screwed into the threaded, C'Sinked holes as s hown. The inside lead exit hole will accommodate the #18E Teflon Lead Wire attached to the START of the internal solenoid coil. Likewise, the outside lead exit hole will accommodate the #18E Teflon Lead Wire attached to the FINISH of the internal coil.
	Again, we have a view of the inside face of the Back End Plate. Here we show the inserts (screws) fully seated and trimmed too allow the inside and outside steps to mate with the I.D. Sleeve and Housing Shell respectively. Once the sleeve and shell are in place the inserts can not rotate or come loose.
	This view shows the outside face of the Back End Plate with Lead Exit Inserts in place.

[TOC] [PREVIOUS] [NEXT]